BaByliss E700XTE Manual Del Usuario página 6

The first 4 cutting guide allows
3 different cutting lengths. To
adjust the cutting length, hold
and press the two buttons on
each side of the clipper head
while pivoting the guide in order
to block it in one of the three
positions.
Presicion cutting guide allows
5 cutting lengths (from 0,5 to
2,5 mm). To adjust the cutting
length, push the switch button at
the back of the precision cutting
guide from one position to the
other in order to block it in one of
the five positions.
To remove the cutting guide,
hold and press the two buttons
on each side of the clipper head
and pull the guide up.
6
CUTTING TECHNIQUES
• Only use the clipper on clean
and dry hair.
• Use the cutting guide that leaves
the hair the longest at first, until
you become familiar with the
clipper. If you want a shorter cut,
use the next shorter cutting
guide and go over hair again till
you achieve the desired length.
• Always cut hair against the
natural direction of hair growth.
• Start cutting from the back of the
neck to the crown. Hold the clipper
lightly against the hair with the
teeth of the cutting guide pointing
upwards, yet flat against the
head and gradually lift the clipper
upwards through the hair. Always
maintain the clipper against the
head while cutting.
• For the top of the head, clip
from the front to the back.
• Outlining requires no cutting
guide: for close trimming of the
back of the neck and the
contours, slide off guide, reverse
the clipper and trim downwards.
• For longer hair (hair length
greater than 27 mm) or if you
are experienced enough, you
can realise the hair cut using a
comb or your fingers :
- Use the clipper with no attachment
- Lift a small strand of hair with
the comb or hold it between
the fingers
- Move the comb or your fingers