Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch
having a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance)
being sure that the connector of the feeding cable is cor-
rectly inserted in the socket placed on the side of the fan.
Chimney assembly
Upper chimney section
• Slightly widen the two sides of the upper chimney and
hook them behind the brackets 7.2.1, making sure that
they are properly housed.
• Secure the sides to the brackets using the 4 screws 12e
(2,9 x 9,5) supplied.
Lower exhaust flue
• Insert the lower flue fixing bush 17 in the top of the hood
body and rotate it 90° clockwise as far as it will go.
• Slightly widen the two sides of the chimney and hook
them between the upper chimney section and the wall,
making sure that they are properly housed.
• Secure the sides of the bottom section to the bushes pro-
vided using the 2 screws 12c (2,9 x 9,5) supplied.
• On the recirculation version, fit the directional grids 8a –
8b in their housings making sure that the directional
symbols are towards the top and front of the hood. Also
make sure that they are correctly inserted in the outlet
connection piece 15.
EN
7.2.1
2.1
2
2.2
8b
1
12e
8a
12e
17
1
19
Publicidad
