Descargar Imprimir esta página

Truper ESMA-9N3 Manual página 8

Ocultar thumbs Ver también para ESMA-9N3:

Publicidad

Auxiliary handle assembly
• For a safer operation use the auxiliary handle. Fit it
into any of the three mounting orifices. Choose the
one that make your job easier.
The Angle Grinder is a power tool. It is used to grind and cut steel, pipes, and angles in iron, bricks, tiles, stone and/or
ceramic pieces. Also to remove burr from metal surfaces, to level and smoothing out soldering. When changing the tool
accessory it can be used to clean rust and to buff metal surfaces and other materials.
Turning On
• Intermittent operation:
Connect the plug into the power outlet.
A ) to start the tool.
Press switch (
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
A ) and block it pressing the continuous use button ( B ).
Press switch (
To stop, press and then release the switch.
Handle rotation
• Regarding the job, the angle grinder handle can be rotated to operate the tool
more comfortably. Press the handle rotation-blocking button (C). Turn into the
desired position until a "click sound is heard".
How to properly hold the tool
Always use the tool with both hands. One hand holds the
handle and the other hand on the auxiliary handle.
Be careful not to obstruct the ventilation slots.
• Grinding:
For better results hold the tool at and angle of 15° to 30°
with regards to the work piece. Move backward and forward
with a constant rhythm and a slight pressure. This way the
work piece will not get too hot, will not fade and will not
have rough edges.
• Cutting:
Do not press, tilt or oscillate the tool. Use a moderate speed.
The disc should always rotate in a movement opposite to the cutting
movement. Never do it the other way around. There is danger the tool shoots
out of control.
For cutting stone we recommend using a diamond disc.
8
ENGLISH
C
Preparation
Start Up
A
C
B

Publicidad

loading

Este manual también es adecuado para:

12482