Publicidad
Start Up
Useful Tips
• To prevent damaging the disc work using the disc into the right position.
• Press onto the work piece using less force than the tool's weight to avoid overload and
damaging the motor and disc.
• After installing a new disc allow the disc to rotate at least during one minute without working on
the piece. If it vibrates, replace it immediately.
CAUTION
• Avoid working onto wood or soft materials like lead. These materials saturate
the disc very fast and make it unusable.
Maintenance
• Before cleaning the tool verify it is unplugged.
• Never use water or other liquids. Use only a brush.
• To avoid overheating of the motor, clean the ventilation slots regularly.
• Double-check all the tool components are securely fastened.
• The housing should not be cracked or damaged.
• After a prolonged use the grease on the tool head should be replaced in a
Authorized Service Center.
Repairs
• Use only spare parts and accessories recommended by the manufacturer. In
case the tool is not working, repairs should be done in a
Authorized Service Center.
Carbon Brush Replacement
• Replace worn (burnt, broken or smaller than 0.19" long)
carbon brushes. Use new carbons.
• When changing carbons always change both carbons at
the same time.
• Use a screwdriver to remove the lid from the carbon
brushes.
• Remove worn carbons from the housing. Clean dust with
compressed air.
• Set the new carbons in a reverse order. Carbons shall
easily fall into the carbon housing.
• After setting up new carbon brushes let the grinder
running a couple of minutes with no load. This way the
carbon brushes will adjust better.
• Use only original
brushes, designed specifically with the right hardness and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
• For better results, it is recommended to use grinding
and/or cutting disc to 9"
Storage
Neatly store the tool in a dry place and protected from dust and water .
spare carbon
ENGLISH
9
Publicidad
