Publicidad
Idiomas disponibles
Idiomas disponibles
D_FEATURES OF YOUR i-RACER BOOSTER
SEAT WITH BACKREST
The i-RACER safety seat has been designed using the latest advances in
safety and comfort:
• The height of the shoulder belts is adjusted without the need to remove the
belt. This action is connected to the headrest that offers better protection in
the event of side impact while simultaneously supporting the head. It has 11
different height positions.
• The interior of the seat is covered with shock absorbing material.
• The seat can be reclined in 4 different positions.
• It is fitted with a spacer element that provides extra protection in the event
of side impact.
E_INSTALLATION WITHOUT ISOFIX ANCHORS
• If you decide to install the i-RACER booster seat with backrest without the
ISOFIX anchors, simply position the safety seat on the vehicle seat, pass the
seat belt through the lower belt guides (6) and the one found on the side of the
headrest (5). These guides are marked green.
18
EN
1
F_INSTALLATION WITH ISOFIX ANCHORS
The booster seat with backrest can be fastened with the ISOFIX anchors,
which gives it greater lateral stability.
• The ISOFIX anchors (4) are extracted by pressing the buttons (4a).
In some vehicles, the ISOFIX anchors can be difficult to access or they are
concealed between the foam of the vehicle seat. The safety seat comes with
two guides (11) making it easier to locate the anchor points. Insert the guides
before the next step.
• Guide the anchors towards the axles in your vehicle and press until both
sides are locked into place, two green signals on the sides of the anchors (4b)
will indicate that they are anchored in place. If one or both of the signals is
red, try again.
2
.a
+
2
.b
• Press the booster seat against the backrest of the vehicle seat.
G_ADJUSTING THE HEIGHT OF THE HEADREST
The height of the headrest can be adjusted using the handle found on the
back of the headrest (9). To release it pull the handle upwards, when you
release it, the headrest will lock into the nearest position.
• Pass the shoulder section of the vehicle seat belt through the belt guide on
the side of the headrest (5).
• Seat the child in the booster seat, and adjust the height of the headrest
using the handle (9). The seat belt should be slightly above the child's shoul-
3
der.
.b
2
.c
3
.a
Publicidad
