JANE iRACER Manual De Instrucciones página 21

H_POSITIONING THE CHILD IN THE SEAT
• Seat the child in the booster seat and pass the shoulder section of the
vehicle seat belt through the belt guide on the side of the headrest (5).
• Pass the seat belt over the child and fasten the buckle.
• Lastly, pass the seat belt underneath both lower guides (6).
When getting the child out of the booster seat it is not necessary to take the
seat belt out of the belt guide on the side of the headrest (5). This makes it
easier to fasten the child in next time the booster seat is used.
ATTENTION: Even when not in use, the booster seat must be secure-
!
ly fastened in place with the seat belt because in the event of sudden
braking or an accident it could get flung about and injure the other
occupants of the vehicle.
To remove the booster seat:
• Release the ISOFIX anchors by pressing the buttons (4a). The signals on
the side (4b) will turn red.
• Remove the booster seat. Press the ISOFIX anchors (4) to store them
away inside the base.
I_RECLINING THE SEAT
i-RACER can be reclined by using the lever found on the front of the seat (8).
4
.a
It has 4 reclining positions.
4
.b
4
.c
ATTENTION: This action requires the 3-point seat belt to be adjusted
!
and should only be carried out while the vehicle is stationary.
• To recline the seat, pull the lever on the front and slide the seat to the
required position.
J_USING THE SIDE PROTECTOR
Your booster seat is fitted with a spacer which, in the event of side impact,
creates some distance between the backrest of the seat and the collision
zone.
This spacers should be placed on the side nearest the vehicle door.
• To install it or remove it, press the button found on the top of the spacer.
5 5
.a + .b
6
EN 19