Publicidad
Idiomas disponibles
Idiomas disponibles
GENERAL INFORMATION
Make sure to use the studs in your wall before mounting the wall plate.
Do not mount this product into the drywall
▶Distance min / max. the wall: 80-210mm
▶Arm swivel angle, left and right: 180º
▶Tilt angle: -15º/+15º
PARTS INCLUDED
A. Fixing bolt M8x50 (4x)
B. Plug M10x50 (4x)
C. Fixing screw M6x20 (4x)
D. Fixing screw M8x25 (4x)
E. Fixing screw M5x20 (4x)
F. Washer (8x)
H. Fixing key (1x)
WARNING
▶Use caution when hanging heavy objects
▶Hang only flat screen televisions on wall mount
▶Not for children
Nota
Please note it is recommended that this product requires
fixing by a professional to avoid accidental damage or
injury. The supplier will not be held liable for damage
caused by inadequate fixing
INSTALLATION
▶1. Drill two holes into the wall taking care to measure the distances
to fit the wall mount (G). Insert the two plastic anchors (A) into the
holes and then affix the wall mount to the wall by inserting the two
heavy duty screws (B) through the slots and into the anchors. Use a
drill to secure.
▶2. Install the TV on the articulating plate by using parts (C/D/E),
choose the suitable one to fit your TV. The washers (F) are provided
to ensure a better fit.
Instruction manual
A.
B.
C.
D.
E.
F.
G.
H.
▶3. Loosen the knob to adjust the angle of the TV between -15/+15
degrees to a suitable position, and then screw the knobs firmly.
INSTALLATION ON DRYWALL
Use a stud finder to locate two adjacent studs where you with to instal.
your mount. Use the wall plate as a template to mark four holes..
Drill a pilot hole at each marked location.
Fix the wall plate onto the wall using the concrete anchors and lag bolts
provided..
Choose proper screws to fix the mount to the back of your display.
Spacers and longer screws should be used if the back of your display is
curved or recessed.
ref. 50131
ES
PT
EN
FR
Publicidad
