Bottle Rack (Some Models); Covered Utility Bin; Dairy Compartments; Door Buckets - Sears Kenmore 10937045 Manual De Uso Y Cuidado

Refrigerador con montaje inferior
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1.
Remove drawer by lifting and pulling out. Remove
shelf by lifting from front, releasing hooks from metal
track, then pulling out
2
Remove plastic cap from back walt of refrigerator
section by placing a knife covered with masking tape
underneath cap and pulling forward
3.
Insert plastic cap in opposite side of Fresh Food
section Confirm cap is snugly in ptace Cold air
may cause food to freeze if cap is not replaced.
4
Rotate boot 180 ° to opposite side.
5.. Replace shelf by inserting hooks into metal track and
lowering the front Use slots 4 though 6 only_
6.
Replace drawer by sliding in. Make sure boot fits
snugly over air inlet in back wall
Covered
Utility Bin
The utility bin has a Iid and removable egg tray.When tray
is removed, bucket will accept standard egg carton, ice,
etc.
m
B
C
E
Meat dlawet installed on left side of refrigerator.
2 Meat drawer drawer installed on right side of
refrigerator.
A Air inlet
D Metal rack
B Boot
E
Controls
C Plastic cap
Bottle
Rack (some
models)
Bottle rack provides convenient storage for a large bottle,
eggs, etc
Hang rack by hooking over side of shelf.
Dairy Compartment
Dairy compartment provide convenient storage for butter,
cheese, etc..
Remove dairy compartment by lifting door, pushing
tabs of shelf down on both sides, and pulling out.
Replace dairy compartments by sliding in until
tabs lock into place, then lower door
A
Door
B
Tab
Door Buckets
Door buckets adjust to meet individual storage needs
Remove door buckets by pushing tabs on both
sides of shelves toward center and putling bucket
out,
Replace door buckets by sliding in until tabs lock
into place,
A
Tabs
Bottle holder
A

Publicidad

Tabla de contenido
loading

Tabla de contenido