Removing and Replacing the Ice Storage Bin
1. Press down the release lever and tilt the bucket outward. Use
both hands to hold the base of the storage bin, then lift it up
and out.
A. Release lever
NOTE: It is not necessary to turn the ice maker control to the
OFF (right) position when removing the storage bin. The
sensor cover ("flipper door"), located on the right wall of the
freezer door, stops the ice maker from producing ice if the
door is open or the storage bin is removed.
A
A. On/Off switch
B. Sensor cover
2. Replace the bin by sliding it onto the door, then tilting it
back into an upright position. The release lever will click
when the bin is securely in place.
14
REFRIGERATOR FEATURES
Your model may have some or all of these features. Features
that can be purchased separately as product accessories are
labeled with the word "Accessory." Not all accessories will fit all
models. If you are interested in purchasing one of the
accessories, please call the toll-free number on the back cover
or in the "Accessories" section.
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
Tempered glass is designed to shatter into many small,
A
pebble-size pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
To Remove and Replace the Bins:
1. Remove the bin by lifting it and pulling it straight out.
2. Replace the bin by sliding it in above the desired supports
and pushing it down until it stops.
B
To Remove and Replace the Bottle/Can Rack:
1. Remove the bottle/can rack by lifting it and pulling it
straight out.
2. Replace the bottle/can rack by sliding it in above the
desired supports and pushing it down until it stops.
Refrigerator Door Bins
(on some models)
Bottle/Can Rack
(on some models)