Publicidad
Idiomas disponibles
Idiomas disponibles
Setting the power
The blade track is set at the optimum setting ex-factory. However,the blade
track can change as a result of voltage flutuations.in the event of under voltage,
the blade track can shorten and, in the event of over voltage, it can lengthen.
If necessary, by changing the setting of the adjusting screw, you can set this
blade track yourself. To do so, use a screwdriver or a thin coin.
• Using the on/off switch, switch the equipment on (Fig.1a).
• Turn the adjusting screw clockwise until you hear a loud noise (Fig.2b).
• Then turn the adjusting screw anticlockwise until the loud noise stops.
(Fig.2a).
Cutting-length adjustment
With the adjustment lever at the side, the cutting length can be steplessly ad-
justed even during operation.
• lift the adjustment lever upwards-minimum cutting length (Fig.3a).
• lower the adjustment lever-maximum cutting length (Fig.3b).
Cutting with attachment combs
depending on the desired haircut, the equipment can be operated with or
without attachment comb. To this end, the cutting -length adjustment lever has
to be raised (Fig.3a).
attachment combs 1 (3mm), 2 (6mm), 3 (9mm) or 4 (12mm) are included in
the scope of supply.
Attaching/removing the attachment comb
• Place the attachment comb onto the cutting edge of the cutting set and
press it down onto the cutting set in the direction of the housing until it
clicks into position (Fig.4a).
• The attachment comb can be easily removed by lifting the hook in the
direction of the arrow (Fig.4b).
Cleaning and Care
• do not immerse the equipment in water!.
16
ENGLISH
Publicidad
