Publicidad
Idiomas disponibles
Idiomas disponibles
• disconnect from the mains.
• Undo both screw on the cutting set,remove the clipping comb and clip-
ping blade (Fig.6).
• When assembling, the clipping comb and clipping blade should be alig-
ned as follows (Fig.7).
• raise cutting-length adjustment lever-shortest cutting length (Fig.3a).
• The distance between the front edge of the clipping comb and the front
edge of the clipping blade should be between 0.8mm and 1.6mm (Fig.7a).
• The clipping comb and clipping knife should be parallel to each other.
• The first tooth of the clipping blade (from the left) must cover the first
tooth of the clipping comb or be located slightly to the left of this.(Fig.7b).
• The outermost tooth of the clipping blade (on the right) must touch the
outermost large tooth of the clipping comb (on the right) (Fig.7c).
• Tighten both screws (Fig.6).
• This product is to be returned to the appropriate municipal waste collec-
tion facility for recycling and recovery.
Important Instructions
• For domestic Use only.
• For your own protection, the following information must be observed
when using electrical equipment (read all the instructions before using the
equipment).
• animal clippers are intended for trimming /grooming purposed only.
• only connect the equipment to an alternating voltage, note the rated
voltage.
• Never touch electrical equipment that has fallen into water.
• disconnect from mains immediately.
• Never use electrical equipment in the bath or shower.
• always position or store electrical equipment where it cannot fall into wa-
ter (e.g.wash basin). Prevent electrical equipment from into contact with
water and other liquids.
18
ENGLISH
Publicidad
