Festool SYSROCK BR 10 Manual De Instrucciones página 12

English
9 General information
The company reserves the right to
amend the specification without notice.
9.1
Information about Bluetooth
As soon as the tool is connected to the
mobile device via Bluetooth
secure connection has been authorised,
the tool will connect automatically to
the mobile device from this point on­
wards.
The Bluetooth ® word mark and the
logos are registered trademarks of
Bluetooth SIG, Inc.; they are used by
TTS Tooltechnic Systems AG & Co. KG,
and therefore by Festool, under licence.
9.2 USA: Federal Communications
Commission (FCC) Interference
Statement
NOTE: This equipment has been tested
and found to comply with the limits for a
Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable pro­
tection against harmful interference in
a residential installation. This equip­
ment generates, uses and can radiate
radio frequency energy and, if not in­
stalled and used in accordance with the
instructions, may cause harmful inter­
ference to radio communications. How­
ever, there is no guarantee that inter­
ference will not occur in a particular in­
stallation. If this equipment does cause
harmful interference to radio or televi­
sion reception, which can be deter­
mined by turning the equipment off and
on, the user is encouraged to try to cor­
rect the interference by one or more of
the following measures:
– Reorient or relocate the receiving
antenna.
12
–
–
®
–
® and the
NOTE: Any changes or modifications not
expressly approved by the party respon­
sible for compliance could void the us­
er's authority to operate the equipment.
9.3
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada's licence-exempt
RSS(s). Operation is subject to the fol­
lowing two conditions:
(1) This device may not cause interfer­
ence.
(2) This device must accept any interfer­
ence, including interference that may
cause undesired operation of the de­
vice.
9.4
The radiated output power of the Wire­
less Device is below the Innovation, Sci­
ence and Economic Development (ISED)
radio frequency exposure limits. The
Wireless Device should be used in such
a manner such that the potential for hu­
man contact during normal operation is
minimized.
Increase the separation between the
equipment and receiver.
Connect the equipment into an out­
let on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experi­
enced radio/TV technician for help.
Canada: RSS Compliance
Statement
Canada: Radio frequency (RF)
Exposure Information