Festool SYSROCK BR 10 Manual De Instrucciones página 8

English
Battery is fully charged
Battery is partially charg­
ed
Battery low - charging re­
quired
battery critical - alterna­
tive power source re­
quired immediately.
6.6 Using the radio – FM (VHF)
► Align antenna [1-3].
Press Source [j] until FM
►
mode has been selected.
Automatic station search: FM (VHF)
► Press and hold station
search [i], [h] (~1s) to start the au­
tomatic station search.
The station search is automatically
ended when a station with a sufficient
signal strength has been found.
The display shows the frequency. If the
signal is strong enough and RDS infor­
mation is available, the display shows
the station name, the radio text and the
time.
Finding other stations
► Press station search [i], [h] as de­
scribed above.
When it reaches the end of the frequen­
cy band, the search jumps back to the
start of the frequency band.
Realign the antenna in the event
of poor reception.
Manual station search – FM (VHF)
► Press station search [i], [h] several
times until you reach the desired
frequency.
8
The frequency goes up/down in incre­
ments of 0.1 MHz.
6.7 Using a preset
Popular radio stations can be saved in a
preset. There are four presets availa­
ble.
► Press and hold presets [b], [c], [f]
or [g] (~1s) until <SET MEMO> is
shown on the display.
The station is saved under the selected
preset. The display shows preset num­
bers P1 to P4.
Repeat this step for further presets.
Presets can be overwritten with a new
station in the same way.
Calling up presets
► Press the desired pre­
sets [b], [c], [f] or [g] in order to get
to the saved station.
6.8 Time – Radio Data System
The radio synchronises the time and
shows it in display [d] when a station is
selected that provides RDS information
with CT signals. If a signal is strong
enough, the time is updated within one
to two minutes. The radio time is up to
date for the next 24 hours when the ra­
dio is synchronised with RDS-CT.
If no RDS signal is received, the
time is not shown.
6.9 Listening to music via
Bluetooth ®
SysRock and the Bluetooth
must be coupled with each other in or­
der to play back music via the
Bluetooth ® device. Two devices can rec­
ognise each other through this "cou­
pling".
streaming
®
device