HMF 4612112 Manual De Usuario página 5

EN
English
Instruction Manual
Art.-No.: 4612112, 4612212, 4612312, 4612412, 4612512
7. Anchoring the safe
In order to miniminze the risk of theft, the safe should be fixed at the rear panel using the 4 holes. For anchor-
ing the safe onto a concrete base, the appropriate anchoring material is included in the delivery. Equivalent
anchoring material has to be used for other surfaces, depending on the local conditions.
7.1 Hold the safe in the desired position and mark the boreholes with a pen.
7.2 Drill the holes for the expansion anchors.
7.3 Insert the expansion achors into the prepared holes.
7.4 Hold the safe in position (at the prepared boreholes) and fix the safe on the wall with the delivered
screws.
7.5 Please check that the safe is securely fixed and tighten the screws, if necessary.
wall
ISSUES
The opening mechanism is sluggish or the
vault opens only sometimes or not at all.
The green and red LEDs light up
simultaneously, the safe will not open.
When pressing the buttons no sound is
heard.
When pressing the buttons no LEDs light
up.
The door is warped, the vault closes
hardly.
The safe opens with any code or, the
stored code is not working.
Instruction Manual © Gebr. Holthoff, www.hmf-shop.de, info@hmf-shop.de
safe
Abb. 4 / fig. 4
CAUSE / HANDLING
Weak batteries / Please open the safe with the emergency key and
insert new batteries. ATTENTION! Please note 5. Battery replace-
ment! The code has to be restored.
Weak batteries / Please open the safe with the emergency key and
insert new batteries. ATTENTION! Please note 5. Battery replace-
ment! The code has to be restored.
Weak batteries / Please open the safe with the emergency key and
insert new batteries. ATTENTION! Please note 5. Battery replace-
ment! The code has to be restored.
Or the sound signals are switched off (see 6. Turning off the sound
signals).
Weak batteries / Please open the safe with the emergency key and
insert new batteries. ATTENTION! Please note 5. Battery replace-
ment! The code has to be restored.
Please adjust the safe door with using an Allen key.
The batteries may have been changed and you haven't stored a new
code. Please open the safe with the emergency keys and store a
new code as describe under 3. Storing the personal code.
5