Technaxx TX-28 Manual Del Usuario página 4

6. Remote Control
7. Charging the Receiver
Plug the Micro USB cable* (* included) into the Micro USB slot of the receiver. Then
connect the USB port to the USB slot of a PC or an USB 12V/1A charging adapter*
(* included). Charging time is ~ 3–4 hours. While loading, the RED LED lights
continously. When the receiver is fully loaded, the RED LED turns off.
8. MAIN MENU
Press the Menu key to display the main menu, and the below picture is shown on the
wireless digital video receiver display with the different modes you can select.
Playback – Record – Select Camera – Contrast/Brightness
Recording schedule – Motion Detection – Settings – Exit
Menu: Press Menu key to show Main Menu.
Cam: Press Camera key to change channels.
Screen: Press Screen key to show 4 video same
time, press it again, video auto to show one by one,
press it again to enlarge one of 4 video.
Rec: Press Video Record key to record a video,
press it again to stop recording.
Press OK key (round key in the middle) to confirm
the selection.
Press UP / DOWN / LEFT / RIGHT navigation key
(the keys with the arrows) to select the mode