Maxx 21038 Manual De Usuario página 41

HOW TO MIX FUEL
RECOMMENDED MIXING RATIO
GASOLINE 25 : OIL 1
Mix a regular gasoline(leaded or
unleaded, Alcohol-free)and a
quality-proven motor Oil for air
cooled 2 cycle engines.
25:1 MIXING CHART
GASOLINE liter 0.5 1 1.5 2
2-CYCLE OIL ml 20 40 60 80 100
WARNING
Pay attention to agitation.
1. Measure out the quantities of
gasoline and oil to be mixed.
2. Put some of the gasoline into a
clean, approved fuel container.
3. Pour in all of the oil and agitate
well for 10seconds.
4. Pour in the rest of gasoline and
agitate again for at least one
minute. As some oils may be
difficult to agitate depending on
oil ingredients, sufficient agitation
is necessary. Be careful that, if
the agitation is insufficient, there is
an increased danger of early
piston seizure due to abnormally
lean mixture.
5. Place a clear indication on the
outside of the container to avoid
mixing up with gasoline or other
containers that dont contain oil.
6. Indicate the contents on outside of
container for easy identification.
FUELING THE UNIT
1. Untwist and remove the fuel cap.
Rest the cap on a clean
surface.
2. Put fuel into the fuel tank to 80% of
the full capacity.
3. Fasten the fuel cap securely and
wipe up any fuel spillage around
the unit.
WARNING
1. Select flat and bare ground for
fueling.
2. Move at least 10 feet (3 meters)
away from the fueling point
before starting the engine.
3. Stop the engine before refueling
the unit. At that time, be sure to
sufficiently agitate the mixed
gasoline in the container.
WARNING
FOR YOUR ENGINE LIFE, AVOID
1. FUEL WITH NO OIL (RAW GASOLINE) –
It will cause severe damage to the
internal engine parts very quickly.
2. GASOHOL – It can cause deterioration
of rubber and/or plastic parts and
disruption of engine lubrication.
3. OIL FOR 4-CYCLE ENGINE USE – It
can cause spark plug fouling, exhaust
port blocking, or piston ring seizure.
2.5 4. Mixed fuels which have been left unused
for a period of one month or more may
clog the carburetor and result in the
engine failing to operate properly.
5. In the case of storing the product for a
long period of time, clean the fuel tank
after rendering it empty. Next, Start the
engine and run the carburetor dry
residual fuel.
6. In the case of scrapping the used mixed
oil container, scrap it only at an
authorized depository site.
As for details of quality assurance, read
the description in the section Limited
Warranty carefully. Moreover, normal
wear and change in product with no
functional influence are not covered by
the warranty. Also, be careful that, if the
usage in the instruction manual is not
observed as to the mixed gasoline, type of
oil or fuel to be used. described therein, it
may not be covered by the warranty.
NOTE
41