Bosch GOP40-30 Instrucciones De Funcionamiento Y Seguridad página 10

2610041405.qxp_GOP 3/14/16 7:56 AM Page 10
VARIABLE SPEED DIAL
This tool is equipped with a variable speed
dial. The speed may be controlled during
operation by presetting the dial in any one of
six positions (Fig. 1).
OPERATING SPEEDS
The Bosch oscillating tools have a high
oscillating motion of 8,000 - 20,000 /min
(OPM). The high speed motion allows the
Bosch tools to achieve with excellent results.
The oscillating motion allows the dust to fall
to the surface rather than slinging particles
into the air.
To achieve the best results when working
with different materials, set the variable
speed control to suit the job (see Speed
Range chart at right for guidance). To select
the right speed for the accessory in use,
practice with scrap material first.
NOTE: Speed is affected by voltages
changes. A reduced incoming voltage will
slow the OPM of the tool, especially at the
The GOP40-30 and GOP55-36 are compatible with StarLock family of accessories as
indicated in the following chart
Accessory
serious personal injury and property damage.
Accessories
Accessory
Model Number Range
OSL
OSP
OSM
Only use Bosch accessories rated 21000 OPM or greater.
Using accessories not designed for this power tool may result in
-10-
lowest setting. If your tool appears to be
running slowly, increase the speed setting
accordingly. The tool may not start at the
lowest switch setting in areas where outlet
voltage is less than 120 volts. Simply move
the speed setting to a higher position to
begin operation.
The variable speed control settings are
marked on the speed control dial. The
settings for approximate /min (OPM) are:
Speed Dial
Setting
1
2
3
4
5
6
GOP40-30
YES
YES
NO
Speed Range
/min (OPM)
8,000
10,400
12,800
15,200
17,600
20,000
GOP55-36
YES
YES
YES