Plunge Cuts - Bosch GOP40-30 Instrucciones De Funcionamiento Y Seguridad

2610041405.qxp_GOP 3/14/16 7:57 AM Page 18
OSC004 Depth Stop Kit
(Optional Attachment)
INTRODUCTION
The OSC004 Depth Stop Kit attachment is
compatible with the Bosch GOP40-30 and
GOP55-36 Oscillating Tools and allows the
depth of a cut to be limited to a user-selected
depth. (FIG.A) It can also be used to provide
guidance for other types of cuts. (FIG. B)
INSTALLATION
Step 1: If an accessory has already been
installed on the tool, remove it.
Step 2: Place the bracket onto the nose of
the tool such that the clamp is facing
the rear of the tool. (FIG. C)
Step 3: Press the clamp shut. (FIG. C)
Step 4: Push the appropriate guide into the
opening in the front of the bracket.
Step 5: Install the accessory onto the tool.
Step 6: Set the desired cutting depth using
the red button on the side of the
bracket. (FIG. C & D)

PLUNGE CUTS

• For plunge cutting using round blades,
such as "segment" blades, install the wide
stop as shown in figure D.
• For plunge-cut blades using straight
blades, install the narrow stop as shown in
figure E.
OTHER TYPES OF GUIDED CUTS
• For other types of guided cuts, install the
wide stop as shown in figure B.
D
Attachments
A
B
C
E
-18-