Publicidad
Idiomas disponibles
Idiomas disponibles
Recommended separation distances between portable and mobile RF communications equipment and
The Device is intended for use in an electromagnetic environment in which radiated RF disturbances are con-
trolled. The customer or the user of the Device can help prevent electromagnetic interference by maintaining a
minimum distance between portable and mobile RF communications equipment (transmitters) and the Device as
recommended below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
W
0,01
0,1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in
metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P is the maxi-
mum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
Guidance and manufacturer's declaration - electromagnetic emissions
The Device is intended for use in the electromagnetic environment specified below. The customer or the user of
the Device should assure that it is used in such an environment
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
.............................................................................................................................
DRIVE COMPRESSOR/NEBULIZER MODEL MQ5800, MQ5900, MQ5900P
.............................................................................................................................
the []
Separation distance according to frequency of transmitter
150 kHz to 80
MHz (out ISM
MHz (in ISM and
and amateur
amateur radio
radio bands)
d = 1.2√p
0.12
0.38
1.2
3.8
12
Compliance
Electromagnetic environment - guidance
Group 1
The Device uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment.
Class [B]
The Device is suitable for use in all establishments Includ-
ing domestic and those directly connected to the public
low-voltage power supply network that supplies buildings
Class A
used for domestic purposes.
Complies
m
150 kHz to 80
80MHz to
800MHz
d = 1.2√p
bands)
d = 2√p
0.2
0.12
0.632
0.38
2
1.2
6.32
3.8
20
12
800MHz to
2.7GHz
d = 2.3√p
0.23
0.73
2.3
7.3
23
15
Publicidad
