Pit Boss ULTIMATE GRIDDLE Serie Guía De Montaje página 5

2. ASSEMBLING THE CART BASE
Parts Required:
1 x Bottom Shelf (#26)
4 x Screw (#A)
4 x Washer (#C)
4 x Locking Washer (#D)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit
and parts during assembly.
NOTE: Ensure the flat surface of the Bottom Shelf is facing up.
• Attach the Bottom Shelf to one Support Leg with Wheel by carefully
aligning it into the corner, then secure using one washer, locking washer,
and screw. Repeat installation for the other three Support Legs to the
remaining three corners of the Bottom Shelf. See illustration for proper
arrangement of the Support Legs.
IMPORTANT: There are three holes on the short side of the Bottom
Shelf. See proper positioning in illustration. If installed incorrectly,
the gas tank cannot be placed in future steps.
3. MOUNTING THE CART PANELS
Parts Required:
1 x Cart Front Panel (#8)
1 x Cart Back Panel (#9)
1 x Cart Side Panel - Left (#10)
1 x Cart Side Panel - Right (#11)
16 x Screw (#A)
Installation:
• Install the Cart Front Panel between the front Support Legs of the Cart
Base. Secure using two screws into each Support Leg. Repeat same
installation for the Cart Back Panel. Note illustration 3A.
NOTE: Ensure the "PIT BOSS" of the Cart Front Panel is facing the
front of the unit. The flat surface of the Cart Back Panel should face
towards the back.
• Install the Cart Side Panel Left between the left Support Legs of the
Cart Base. Secure using two screws into each Support Leg. Repeat same
installation for the Cart Side Panel Right to the right Support Legs of the
Cart Base. Note illustration 3B.
IMPORTANT: The latches on the Cart Side Panels should face forward.
2
18
17
20
19
26
A
C
D
3A
A
A
9
8
3B
A
10
11
5