Pit Boss ULTIMATE GRIDDLE Serie Guía De Montaje página 6

4. SECURING THE CART BARS
Parts Required:
2 x Cart Bar A (#24)
2 x Cart Bar B (#25)
4 x Screw (#B)
4 x Washer (#C)
4 x Locking Washer (#D)
Installation:
• Secure Cart Bar A and Cart Bar B to each Support Leg, as shown, using
washer, locking washer, and screw.
5. MOUNTING GAS CYLINDER SUPPORTS
Parts Required:
1 x Gas Cylinder Wire Retainer (#14)
1 x Gas Cylinder Support Bracket (#15)
3 x Screw (#A)
3 x Washer (#C)
3 x Locking Washer (#D)
Installation:
• Mount the Gas Cylinder Support Bracket to the Cart Bottom Shelf using
three washers, locking washers and screws. Note illustration 5A.
• Install the Gas Cylinder Wire Retainer between the Support Legs on the
right side of the unit. Insert the hooked end first, then secure by aligning
the other end into the keyhole. Note illustration 5B.
6. SECURING THE SIDE SHELF BRACKETS
Parts Required:
2 x Side Shelf Bracket - Left (#21)
2 x Side Shelf Bracket - Right (#22)
12 x Screw (#A)
12 x Washer (#C)
12 x Locking Washer (#D)
Installation:
• Mount one Side Shelf Bracket to a Support Leg using three washers,
locking washers and screws. Install each screw halfway first, then
tighten completely when all three screws are mounted and aligned
properly. Repeat installation for the other three Side Shelf Brackets to
the remaining three Support Legs.
6
4
24
C
D
25
B
5A
A
15
A
5B
14
6
21
22
21
25
24
22