Pit Boss ULTIMATE GRIDDLE Serie Guía De Montaje página 8

10. SECURING THE LID SUPPORT
Parts Required:
1 x Lid Support (#5)
3 x Screw (#A)
Installation:
• On the backside of the Firebox, fasten the Lid Support to the center of
the panel using three screws.
11. INSTALLING THE FIREBOX TO THE CART
Installation:
• Place the Firebox next to the Cart, both facing the same direction. Using
two people, lift the Firebox using the inset grooves on each side. Slowly,
place the Firebox onto the cart frame, passing the regulator and hosing
through the Cart side Panel on the right of the unit. Note illustration 11A.
IMPORTANT: Take care to avoid pinching or damaging the regulator
or hosing during installation of the Firebox to the Cart. Poor
installation may cause the parts to not function properly.
• Once in position, turn the latches (one on each side) to lock the Firebox
into the Cart. Note illustration 11B.
12. INSERTING THE HOT PLATE SCREWS
Parts Required:
1 x Hot Plate (#2)
4 x Hot Plate Screws (#3)
Installation:
• Turn the Hot Plate upside-down. Insert a Hot Plate Screw into a corner
hole of the Hot Plate, turning by hand, until it cannot rotate any further
into the nut. Repeat same installation on the other three corner holes.
8
10
5
A
A A
11A
11B
12
3
3
3
2
3