Publicidad
Idiomas disponibles
Idiomas disponibles
3.2.3.
SBS-DFS-12
3.2.3.1.
Turning the scale on/off
Press and hold the "ON/OFF/Tare" button for approximately 3 seconds to turn on the scale. After turning on
the power, all segments of the display will appear for a few seconds and then "0" will be displayed. The scale
is ready for operation.
To turn off the scale, press and hold the "ON/OFF" button for about 6 seconds. The scale will turn off
automatically if it is not used for more than 90 seconds.
3.2.3.1.
Weighing units
Press the UNIT button to select the desired weighing unit.
3.2.3.2.
Tare function
The tare function is the weight of the package itself. It is the difference between the total weight of the goods
with the packaging and the weight of the goods without packaging. The tare is used to remove the weight of
an item that should not be included in the overall weight measurement.
To use this function, turn on the scale and wait for it to stabilize. Then hang a container on the hook, wait for
the reading to stabilize, then press the "ON/OFF/Tare" button and wait for the scale display to show "0.000",
thus indicating that the scale is ready for operation. Place the item in the container and the display will show
the weight of the item itself.
3.2.4.
SBS-DFS-13
3.2.4.1.
Turning the scale on/off
Press and hold the "ON/OFF" button for approximately 3 seconds to turn on the scale. After turning on the
power, all segments of the display will appear for a few seconds and then "0" will be displayed. The scale is
ready for operation.
To turn off the scale, press and hold the "ON/OFF" button for about 6 seconds. The scale will turn off
automatically if it is not used for more than 90 seconds.
3.2.4.2.
Weighing units
Press the UNIT button to select the desired weighing unit.
3.2.4.3.
Tare function
The tare function is the weight of the package itself. It is the difference between the total weight of the goods
with the packaging and the weight of the goods without packaging. The tare is used to remove the weight of
an item that should not be included in the overall weight measurement.
To use this function, turn on the scale and wait for it to stabilize. Then hang a container on the hook, wait for
the reading to stabilize, then press the "ON/OFF" button and wait for the scale display to show "0.000", thus
indicating that the scale is ready for operation. Place the item in the container and the display will show the
weight of the item itself.
3.3.
Cleaning and maintenance
a)
Use only non-corrosive cleaning agents for cleaning the surfaces.
b)
After each cleaning, all parts should be thoroughly dried before the device is reused.
c)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Perform regular inspections of the unit, checking technical fitness and any damages.
f)
Use a soft cloth for cleaning.
g)
Do not leave the batteries in the unit when it will not be used for a long time.
h)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
Publicidad
