Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshoot ing
No sound or only a very low -level sound is heard
f rom t he rear speakers.
/ Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/ Select a sound field from the CINEMA or
VIRTUAL 3D genres (except MONO MOVIE and
STEREO MOVIE) (see page 28).
/ Adjust the speaker volume (see page 18).
/ Make sure the rear speaker size parameter is set to
either SMALL or LARGE (see page 15).
Recording cannot be done.
/ Check that the components are connected correctly.
/ Select the source component with a FUNCTION
button.
/ When recording from a digital component, make
sure the input mode is set to ANALOG (see page
23) before recording with a component connected
to the analog MD/DAT or TAPE terminals.
/ When recording from a digital component, make
sure the input mode is set to DIGITAL (see page
23) before recording with the component
connected to the DIGITAL MD/DAT OUT
terminals.
Radio st at ions cannot be t uned in.
/ Check that the antennas are connected securely.
Adjust the antennas and connect an external
antenna if necessary.
/ The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
direct tuning.
/ Make sure you set the tuning interval correctly
(when tuning in AM stations with direct tuning)
(see pages 38 and 48).
/ No stations have been preset or the preset stations
have been cleared (when tuning by scanning preset
stations). Preset the stations (see page 39).
/ Press DISPLAY so that the frequency appears in
the display.
EN
46
Downloaded from:
https://www.usersmanualguide.com/
The surround eff ect cannot be obt ained.
/ Make sure the sound field function is on (press
SOUND FIELD ON/OFF).
/ Make sure that the SPEAKERS selector is set to A
or B (not A+B) if you connected two sets of front
speakers.
No pict ure or an unclear pict ure appears on t he
TV screen or m onit or.
/ Select the appropriate function on the receiver.
/ Set your TV to the appropriate input mode.
/ Move your TV away from the audio components.
The rem ot e does not f unct ion.
/ Point the remote at the remote sensor g on the
receiver.
/ Remove any obstacles in the path between the
remote and the receiver.
/ Replace all batteries in the remote with new ones,
if they are weak.
/ Make sure you select the correct function on the
remote.
/ If the remote is set to operate the TV only, use the
remote to select a source or component other than
TV before operating the receiver or other
component.
Ref erence sect ions f or clearing t he
receiver's m em ory
To clear
All memorized settings
Customized sound fields
See
Page 19
page 35
Publicidad
