Descargar Imprimir esta página

CASO DESIGN Sound & Cool Black Manual Del Usuario página 27

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
3.3 Unpacking
To unpack the device, proceed as follows:
Remove the device out of the carton and remove the
packaging material.
The packaging material cannot be used as a base for the unit.
The appliance may be title by a max angle of 45 °, otherwise
the cooling system can be damaged.
Clean the interior surface with lukewarm water using a soft
cloth.
Only connect the unit to the mains after waiting at least 2 hours and then switch it
on. Only then place food or drinks in the unit.
PLEASE NOTE
Only remove the blue protective fi lm shortly before setting up the device in the
location where it will be used, to prevent scratches and dirt accumulations.
If possible, keep the original packaging for the device for the duration of the guaran-
tee period of the device, in order that the device can be re-packaged properly in the
event of a guarantee claim.
3.4 Setup location requirements
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfi l the following prerequisites:
Place your appliance on a fl oor that is strong enough to support the appliance when
it is fully loaded.
Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight and heat sources may adversely aff ect energy consump-
tion and cooling performance.
This cooling appliance is intended for ambient temperatures of 16–38 °C.
This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near fl am-
mable material.
The device requires an adequate fl ow of air in order to operate correctly. Leave a
clearance of 45 cm around the appliance.
Do not close the ventilation openings in the device housing.
The electrical socket must be easily accessible so that the power lead can be discon-
nected easily, in the case of an emergency.
The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the prerequisi-
tes for the safe use of this device.
For energy saving reasons please ensure that the drawers are
closed when the appliance is turned on.
Adjust the adjustable feet, so that the device is placed even.
CASO Sound & Cool
DE
EN
FR
IT
ES
NL
RUS
SE
PT
27

Publicidad

loading

Este manual también es adecuado para:

Sound & cool whiteSound & cool wood794793792