Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS
Split bush compressor to be used as OEM 334450
Camber arm mounting extraction / insertion tool to be used as OEM 334460
Trailing arm mounting extraction / insertion tool to be used as OEM 334480
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
SAFETY INFORMATIONS
•
Keep children and other persons away from the working area.
•
Do not allow children to play with this tool or its packaging.
•
Do not use the tool if parts are missing or damaged.
•
Use the tool for the intended purpose only.
•
Never place the tool on the vehicle battery. There is a risk of a short circuit.
•
Lifting of vehicles only allowed on the special lifting points.
•
Before starting work under a car always ensure that it is adequately supported by axle stands
or ramps. Chock wheels and ensure that the hand brake is firmly applied.
•
Always use approved eye protection, especially when working under vehicles.
•
Ensure that tools are correctly mounted.
•
Do not over tighten or use undue force as this can cause damage to both tool and component.
•
Do not use an impact wrench with this tool
•
Always use workshop manual for detailed instructions.
•
Always lubricate the screw threads before using the tool.
•
Check & replace any damaged components as required..
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Trailing Arm Bush Tool Set
for BMW Rear Axle
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8829
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
