Publicidad
Idiomas disponibles
Idiomas disponibles
USE
Installing bush (B)
Note
Original rubber mounting size is Ø 46.5mm
It is not possible to install the rubber bush without
compressing and may cause rubber bush damaged.
Use the tool 10 to compress rubber bush until or less Ø
45.3 mm, in this way you can install it easy.
Installing bush (B)
Note
Installation with the tool no.7
With bevel design, it can use from brake disk side, and the rubber
mounting can be installed easily.
Installing bush (B)
Insert new rubber bush by using special tool no.10.
Set in position and tighten.
Draw rubber bush with special tools 6 - 7 - 8 - 9 - 10 into
wheel carrier.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
