Assembly - Kemper AirWatch Instrucciones De Servicio

5 Assembly

Unpacking and assembling the product
Place the product at a location where increased dust exposure is to be
expected or where measurement results are to be queried and signalled.
NOTE
Determining the installation location:
• The product must not obstruct anyone in their working area.
• A power supply must be available in the immediate vicinity.
• The illuminated area should be clearly visible.
• The illuminated surface must not dazzle anyone.
• The product must not be exposed to direct water spray.
• Avoid draughts.
• The ventilation grilles of the product must not be covered.
• Only install the product horizontally or vertically. Do not install the
product upside down with the mobile phone antenna facing
downwards.
Carry out assembly as follows:
1502724-02
Fig. 15: Unpacking
- 51 -
EN