Descargar Imprimir esta página

EHEIM LEDcontrol+ 4200140 Instrucciones De Uso página 12

Ocultar thumbs Ver también para LEDcontrol+ 4200140:

Publicidad

English
Protect the power cable from heat, oil and sharp edges.
Never make technical alterations to the device.
Use only original spare parts and accessories for the device.
Immediately disconnect all equipment in the aquarium from the mains supply fol-
lowing a water leak or the tripping of the residual current protection device.
Always disconnect all equipment in the aquarium from the mains supply when
it is not in use, before you install and / or remove equipment and before all clea-
ning and maintenance work.
The device must not be placed on or inside the aquarium cover.
The electrical data of the device must correspond to the data of the power supply.
This data can be found on the rating plate, on the packaging or in these instructions.
4. Installation
The device is operated in connection with EHEIM powerLED+ lamps and EHEIM
powersupply power supplies. Refer to the operating manual of the lamp, in particular
the chapter about safety, startup, service and maintenance!
Danger! Electric Shock!
Do not place the device on or in the aquarium cover!
4.1 System requirements
Wi-Fi-compatible (smart phone, tablet, notebook etc.)
5. Start-up
5.1 Setting up or connecting to a network
Connect the plug connectors of the EHEIM power supply b and the powerLED+ lamp c with the
LEDcontrol+e a.
When using an EHEIM 2-way switch d Article-number 4200050, multiple powerLED+ can be operated.
Not included in the scope of delivery! The maximum load of the power supply must be observed
(see type plate of the EHEIM power supply of the lamp)
Insert the plug of the EHEIM power supply in the power socket.
The statusLED e of the LEDcontrol+e glows:
• Status LED flashes white: Network is being searched or created.
• Status LED flashes blue: A new network has been created.
5.2 Connection to the Wi-Fi network
Open the network settings of your end device (smartphone, tablet, notebook etc.). Connect the end
device to the Wi-Fi network (SSID) EHEIM light XXXXXXXXX Enter the network security key.
You will find the SSID and the network security key on the label on the back of the device. Alterna-

Publicidad

loading