Storing; Scrapping A Machine; Environmental Information - Nussbaum TTC 500 Manual De Instrucciones

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
If the machine has to be stored for a long time (3-4 months), you should:
1) Lower the vertical carriage completely.
2) Disconnect the machine from the electric power source.
3) Grease all parts that could be damaged if they become too dry:
- vertical carriage slides
- horizontal carriage slides
- spindle shaft
- spindle drive pin.
4) Drain completely the hydraulic power pack reservoir using its drain plug.
5) Protect the machine from dust by covering it with plastic sheets.
Before using the machine after a period in storage:
1) Re-fill the hydraulic power pack reservoir with hydraulic fluid.
2) Reconnect the machine to its electric power source.
When your machine's working life is over and it can no longer be used, it must be made inoperative by disconnecting it from all power sources.
This equipment is considered as special waste material, and should therefore be broken down into uniform parts and disposed of in compliance
with current laws and regulations.
If the packing is polluting or non-biodegradable, deliver them to appropriate handling stations.

ENVIRONMENTAL INFORMATION

This product may contain substances that can be hazardous to the environment or to human health if it is not disposed of properly.
We therefore provide you with the following information to prevent releases of these substances and to improve the use of natural resources.
Electrical and electronic equipments should never be disposed of in the usual municipal waste but must be separately col-
lected for their proper treatment.
The crossed-out bin symbol, placed on the product and in this page, remind you of the need to dispose of properly the
product at the end of its life.
In this way it is possible to prevent that a not specific treatment of the substances contained in these products, or their
improper use, or improper use of their parts may be hazardous to the environment or to human health.
Furthermore this helps to recover, recycle and reuse many of the materials used in these products.
For this purpose the electrical and electronic equipment producers and distributors set up proper collection and treatment systems for these
products.
At the end of life your product contact your distributor to have information on the collection arrangements.
When buying this new product your distributor will also inform you of the possibility to return free of charge another end of life equipment as
long as it is of equivalent type and has fulfilled the same functions as the supplied equipment.
A disposal of the product different from what described above will be liable to the penalties prescribed by the national provisions in the country
where the product is disposed of.

14. STORING

15. SCRAPPING A MACHINE

39
TTC 500