Klafs SL 033 Instrucciones De Operación página 11

Sauna/Infrarot/Softclima/Infraclima
5. Operation
5.8. Ending the program
The bathing or the preselected operation can be stopped while the program is running.
1. The control panel automatically terminates the program at the end of the bathing time
or
2. Ending the bathing program prematurely - press the MODE button until END appears on the
display.
.
Three seconds after the last pressing of the button the selected bathing program ends
automatically. The control system switches automatically to standby. The time appears on the
display.
3. For hygienic reasons empty the water tank and the evaporator system after a Softclima/Infraclima
bath.
'
See Section 5.10., 5.12. - Shutting down the evaporator.
The last used bathing program is stored at the end of the program.
Calling up the bathing programs with the MODE button displays the last used bathing
program first.
Automatic follow-up program after a Softclima/Infraclima bath
.
If the Softclima/Infraclima was in use longer than 10 minutes, the follow-up program starts
automatically when the program ends. Thereby the symbol Dryer
The time remaining to the follow-up program appears on the right digital display together with the
Hourglass symbol .
.
The panel heating heats up again, thus causing an increased exchange of air. This causes the
cabin to be ventilated.
.
At the end of the follow-up program the control panel switches automatically to standby. The time
appears on the display.
Air out the cabin at the end of the follow-up program
4. Temporarily open the cabin door at the end of the follow-up program!
50701103/02.13
appears on the display.
PAGE 11