Connecting The Devices - brennenstuhl RCS 1044 N Comfort IP 44 Instrucciones De Uso

Connecting the devices

The remote control radio signal has a range of up to 25 m
(dependent on structural conditions).
3
The range can be affected by structural conditions (for
example reinforced concrete), electrical conditions (for
example electrical lines) or electromagnetic conditions
(for example telephones). If necessary remove the source
of interference or maintain a suf cient distance to the
source of interference.
To connect the socket switches:
plug the socket switches into sockets.
•
To connect the remote control:
insert the battery into the battery compartment (9).
•
OPERATION
Switching on a socket switch
1. Plug the socket switch (1) into a socket.
2. Plug the consumer into the two-pin earthed socket (2).
3. Press the preset ON key (8), for example 'A', to switch on the
socket switch (1).
The function indicator light (5) illuminates whenever a key is
pressed.
Switching off a socket switch
1. Press the preset OFF key (6), for example 'A', to switch off
the socket switch (1).
The function indicator light (5) illuminates whenever a key is
pressed.
CLEANING
B
Caution! Risk of electric shock.
Before cleaning the device disconnect it from the mains supply.
22