Cramer 2101586 Manual De Instrucciones página 5

WARNING
Do not touch the cut-off blade.
1. Remove the screws from the guard with the supplied hex
wrench.
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
3.3 ATTACH THE AUXILIARY
HANDLE
Figure 3.
1. Loosen the central knob.
2. Remove the cap and the lower support.
NOTE
Do not miss the spring in the support.
3. Put the auxiliary handle in the lower support.
4. Put the cap to the lower support.
5. Put the entire block in its housing on the shaft.
6. Set the auxiliary handle in the comfortable position.
7. Lock the auxiliary handle with the central knob.
3.4 INSTALL THE BATTERY PACK
Figure 4.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
English
4 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
4.1 ON/OFF BUTTON
Push this button to connect and disconnect the electrical
circuit of the machine.
Two green lights on (G): the electrical circuit of the machine
is on (ON). The machine prepares to operate.
If you do not use the machine for more than 1 minute, the
machine stops.
Lights off: the electrical circuit is off (OFF).
Do not keep your finger on the button when you move the
machine to prevent accidental start.
4.2 SPEED BUTTON
1. Push this button to increase cutting means speed
according to grass conditions.
4.3 START THE MACHINE
Figure 5.
1. Push the on/off button.
2. Push the lock-out button and pull the trigger.
4.4 STOP THE MACHINE
Figure 5.
1. Release the trigger to stop the machine.
4.5 OPERATION TIPS
Figure 6.
Keep clearance between the body and the machine.
5
IMPORTANT
WARNING
NOTE
IMPORTANT
WARNING
EN