Teka DHT 85 Serie Manual De Instrucciones página 20

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure that
a steady air flow has been established before
fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel all
the grease from the outlet duct. This prevents
the return of grease, smoke and smells.
ON/OFF
ON/OFF
Decrease selected
funtion
Filter saturation
indicator
Program the working time
• Turn the hood on and select the required
extraction speed
• Select the programming time by pressing
Timer.
• Each press of the button increases the
programming time by 10 minutes, up to a
maximum of 80 minutes.
• To reset the programme, wait for over a
second and press the Timer button again.
• The speed and extraction time are displayed
with the LED indicator.
• The intensive speeds 6, 7 and 8 cannot
be programmed. These must be selected
manually and have a maximum duration of
approximately 10 minutes.
• Clean the filters when all lights of the
• Press "Filter Saturation" to reset this
•If your kitchen hood is made of stainless
Receiver
•If your kitchen hood is painted, use lukewarm
Emitter
•Never use metallic scourers, nor abrasive or
Light
Increase selected
funtion
•Dry the kitchen hood using a cloth that does
Timer
•Do not use vapour cleaners
LED
•To remove the filters from their fittings,
•The metal filters can be cleaned by soaking
•Cleaning in a dishwasher may damage the
•Once clean, leave them to dry off and then
For changing the light bulbs please contact the
manufacturer's nearest Technical Service.
Lamp code: 81483104
Filter saturation indicator
LED indicator begin to flash followed
by an acoustic signal.
feature
Cleaning the metal filters
During cleaning and maintenance
work, make sure the safety instructions
are complied with.
Cleaning and maintenance
steel, use proprietary cleaners mentioned in
the product instructions.
water and a neutral soap.
corrosive products.
not produce fibres.
Cleaning the hood body
press lightly on the locks and then pull them
off.
them in hot water with neutral detergent
until the fat dissolves and then rinsing them
under the tap or using special anti-grease
products. They can also be washed in a
dishwasher. In this case, it is advisable to
stack them vertically to avoid food residues
to stick to them.
metallic surface (blackening it), although
this will not affect its fat retention capacity.
fit them onto the kitchen hood.
Lights