Publicidad
Idiomas disponibles
Idiomas disponibles
Ver 1_ES_EN_12-21_(23-12-2021)_lt
Errors
The water heater control has memory. That means, in case there is an electricity shut down, when it returns
back, controls recover the parameters chosen by customer.
The factory pre-set parameters are:
•
Photovoltaic solar energy: 'activated'
•
Maximum temperature in the tank using photovoltaic solar energy: 75ºC
•
Conventional solar energy AC 230V: 'activated'
•
Maximum temperature in the tank by means of conventional solar energy AC 230V: 35ºC
2.- CLEANING.
The external parts of the water heater may be cleaned with a mild detergent solution. Do not use solvents and
abrasives.
80 ℃ and will remain in this point for an hour to eliminate any
By pressing this button, you activate the 'ANTI-LEGIONELLA'
function. The temperature of the water inside the tank will rise to
bacteria present in the tank. For this function, both the photovoltaic
and the conventional 230V heating element will be used. Once the
cycle is finished, the water heater control returns to the previous
configuration. WARNING! During this cycle you have to take the
utmost precaution against burns if you use the stored water.
This pilot light indicates that the 'anti-legionella' cycle is running.
And this light will blink when water temperature between 75 ºC and
80 ºC to indicate the water temperature is too high to use. When
cycle will finish, this light will be off.
Pressing increases the value. If you are in temperature selection
mode, it is increased. In clock mode, the hour or minute is
increased.
Pressing decreases the value. If you are in temperature selection
mode, it is decreased. In clock mode, the hour or minute is
decreased.
Push button to set the clock and to activate/control the timer.
Long press of 2 s.
The clock setting mode is activated. In the first place, it is situated
in the hour digit. Using the '+' and '-' buttons you can increase or
decrease hour. Make a short press to go to the minutes and use
the '+' and '-' buttons again to modify their value.
The two digits at the bottom indicate the temperature at which you
want the electric water heater operates. You can choose between
the one you want with photovoltaic solar energy and the one you
prefer with conventional energy 230V AC. The default regulations
are 75ºC for photovoltaic and 35ºC for conventional energy
The bottom two digits indicate the current tank temperature.
E1: temperature sensor failure
E2: dry heating element operation.
19
Publicidad
