WPool E35 Guía De Instalación Y Uso página 37

5. Using the remote control
5.1 General presentation
Your heat pump is equipped with a 3-button control programmed by default in hot mode at the factory. To
switch on your heat pump, press the ignition button for 0.5 seconds, to switch it off, press it again for 0.5 seconds.
OFF :
When the unit is in stand by you will see OFF
on the screen. After a while the screen will
turn off and the unit will be put in standby.
LED display
Down Up
ON :
When the heat pump is in operation, the
display shows the current water temperature.
37