Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
• The product is a plug-and-play device and requires no driver
• The maximum distance between the product and USB
• The product will automatically enter sleep mode if it is idle
Before using the product
1. Make sure the batteries
mouse, respectively (see chapter "Installing or replacing batteries").
2. Make sure the USB receiver
computer (see chapter "Installing the USB receiver").
Using the keyboard
− The keyboard is ready to use once the USB receiver
computer.
− If necessary, fl ip down the support feet
− The number lock indicator
for typing numbers.
− The caps lock indicator
− The low battery indicator
Replace the AAA battery
− If you are not going to use the keyboard for a long period of time, remove
the AAA battery from the battery compartment. Store the battery in a cool,
dry place and keep it away from children.
Using the mouse
− Slide the on/off switch
to switch the mouse on.
The optical sensor
The mouse is successfully connected to the USB receiver
computer responds to mouse movements.
− To confi gure the mouse (including the left button
button
7
and right button
computer's operating system.
installation and setup.
receiver is around 33 ft (10 m).
for about 10 minutes. Press any button to turn on the product
again.
15
/
14
1
2
lights up when the caps lock feature is enabled.
3
15
(see chapter "Installing or replacing the batteries").
13
on the underside of the mouse to the ON position
12
lights up when the mouse is switched on.
16
are installed in the keyboard and in the
is inserted into the USB port of your
to tilt up the keyboard.
5
lights up when the number pad is enabled
lights up when the battery power level is low.
8
), go to the mouse setting menu of your
Operation
14
is connected to the
14
once the
6
, scroll wheel/middle
11
Publicidad
