Publicidad
Idiomas disponibles
Idiomas disponibles
1.0 - GENERAL
This manual shows you how to safely install, operate and use the device.
The instructions for use ALWAYS need to be available in the facility where the device is installed.
ATTENTION: installation/wiring/maintenance need to be carried out by qualified staff (as explained
in section 1.3) using appropriate personal protective equipment (PPE).
For any information pertaining to installation/wiring/maintenance or in any case problems that cannot be resolved with the use
of the instructions, it is possible to contact the manufacturer from the address and phone numbers provided on the last page.
1.1 - DESCRIPTION
The closed position indicator switch (CPI SWITCH) is a switch with normally open contact that provides a signal to the closure
of obturator of the valve, gives the possibility to check remote (for example by a control panel that provides a bright signal) if
the solenoid valve is closed.
The CPI can be installed ONLY IF the device is set-up properly (cap under the valve body).
NOTE: the device is not suitable for use in potentially explosive areas (Directive 2014/34/EU).
1.2 - KEY OF SYMBOLS
DANGER: In the event
of inobservance, may
be caused damages to
tangible goods.
DANGER:
In
the
inobservance, may be caused damages
to tangible goods, to people and/or pets.
7
ATTENTION: Attention
event
of
is drawn to the technical
details
qualified staff.
intended
for
Publicidad
