Cover Plate; Hex Wrench Storage; Dust Extraction - Makita 4341CT Manual De Instrucciones

CAUTION:
• Do not open the tool opener excessively, or it may
cause tool damage.
To remove the blade, open the tool opener to the position
shown in the figure. Pull the saw blade out toward the
base.
1
NOTE:
• Occasionally lubricate the roller.

Hex wrench storage

1
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Anti-splintering device
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the anti-splin-
tering device onto the cover plate.
CAUTION:
• The anti-splintering device cannot be used when
making bevel cuts.
001911
1. Jig saw blade
001937
1. Base
2. Hex wrench
2
001954
1. Base
2. Anti-splintering
device
1
2

Cover plate

Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.

Dust extraction

The dust nozzle (optional accessory) is recommended to
perform clean cutting operations.
To attach the dust nozzle on the tool, insert the hook of
dust nozzle into the hole in the base.
The dust nozzle can be installed on either left or right
side of the base.
1
Then connect a Makita vacuum cleaner to the dust noz-
zle.
1
2
6
001953
1
1. Cover plate
2. Base
2
001946
1. Dust nozzle
2. Base
2
001947
001948
1. Dust nozzle
2. Hose for vac-
uum cleaner