Publicidad
Idiomas disponibles
Idiomas disponibles
|
About This Manual
From initial concept and design through final production, your Fill-Rite product is built to provide years of trouble-free use. To ensure the safety
of yourself and those around you, it is critical that this manual is read in its entirety prior to attempting to install or operate your new purchase.
We strongly urge that any installer and operator become familiar with the terms, diagrams, and technical data in this manual and pay close attention to
any DANGER, WARNING, CAUTION, or NOTICE information. At Fill-Rite, your satisfaction with our products is paramount to us. If you have questions or
need assistance with your product, please contact us at 1 (800) 720-5192 or via email at FillriteTech@fillrite.com (M-F, 8 AM – 5 PM ET).
Symbols and Definitions
DANGER
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Emphasizes an area in which personal injury or even death may result from failure to follow instructions properly. Mechanical damage may also occur.
CAUTION
Failure to observe a "Caution" may cause damage to the equipment.
NOTICE
These boxes contain information that illustrates a point that may save time, or be key to proper operation, or clarifies a step.
General Description
The TT10 Series Meters are electronic turbine meters suitable for use in Hazardous Locations and extreme temperatures.
The TT10 Meters feature advanced electronics that eliminate false counts in high vibration and mobile applications without sacrificing the ability to
meter at low flows.
The meter can store and display the current metered amount (batch total), or cumulative metered amount (totalizer) in any of five user selectable
units (ounces, pints, quarts, liters, and gallons).
The meter may be easily adjusted for different fluids by selecting a calibration factor from one of 20 settings.
Power is supplied by two replaceable AA alkaline batteries.
Safety Information
WARNING
To ensure safe and efficient operation, it is essential to read and follow each of the following warnings and precautions.
1.
2.
3.
4.
5.
6.
7.
8.
CAUTION
Wear proper safety equipment when handling hazardous fluids.
fillrite.com
TT10 IN-LINE TURBINE METER
Fuels and Chemicals flowing through the meter may be harmful to your health. Use and disposal of these products is controlled by federal,
state, or local laws and procedures.
Conform to fluid manufacturer's recommended handling procedures when using product and when cleaning meter.
Do not exceed an internal meter pressure.
Improper use or installation of this product can cause serious bodily injury or death.
Ensure the piping and hoses connected to the meter are properly grounded when metering or using near flammable fluids.
DO NOT install additional foot or check valves without use of a pressure relief valve; otherwise the meter may rupture.
To avoid build up of electrostatic discharge, please clean with damp cloth only.
The meter body is made of aluminum alloy. Avoid impact or fraction on meter body.
INSTALLATION AND OPERATION MANUAL
3
Publicidad
