Publicidad
Idiomas disponibles
Idiomas disponibles
SaunaP
UR
5.
Operation
5.5.
Starting the SaunaP
.
Requirement: The setpoint temperature must be reached. The
display.
'
Start sauna operation if required, see Chapter 5.4.
.
It is possible to start the SaunaP
using the SaunaP
- button (optional).
UR
1.
To select the SaunaP
2.
Use the
button to start the form of bathing.
.
If the temperature for the SaunaP
control unit display.
.
During the SaunaP
UR
.
After approx. 20 minutes or a temperature drop of approx. 15 Kelvin in the sauna cabin, the
SaunaP
form of bathing ends automatically. The sauna heater starts heating again.
UR
5.6.
Ending a program
Bathing or preselection mode (Sauna) can be ended during the ongoing program.
1.
The program is automatically ended at the end of the bathing duration or
2.
press the B button until END appears in the display.
3.
The program will be ended if none of the buttons are pressed within 3 seconds.
.
The control unit automatically goes into stand-by mode. The time appears in the display.
5070178/07.02
form of bathing
UR
form of bathing on the control unit or on the internal display
UR
form of bathing, use the left/right
UR
form of bathing has not yet been reached,
UR
form of bathing
appears in the control unit display.
Button:
Description:
A
Light button
B
I/0 button
C
Left/Right buttons
D
Up/Down buttons
E
OK button
symbol must appear in the
buttons on the control unit
appears in the
PAGE 11
Publicidad
