Maintenance - Redstone RS 613 B Instrucciones De Uso

SELECTING ThE FREqUENCY AND
IMPACT ENERGY
Rotate the regulator 6 to choose a position ap-
propriate for the processed material. The con-
stant electronics maintain the frequency and the
impact energy constant, independently of the
load, thus ensuring steady operation mode. It is
recommended to use the operation modes listed
in the table.
Render / Light construction materials
Bricks / Chiselling tiles
Chiselling concrete
Rotate the regulator 6 from position A to position
F to increase the frequency and the impact en-
ergy. The indicator 8 shall blink with green light.
With the regulator 6 in position G the indicator 8
shall glow with constant green light. This mode
is specified by increased impact energy up to
9 J.
AUxILIARY hANDLE
Always use the auxiliary handle.
In order to change the position of the auxiliary
handle, loosen the tightening nut 11. Turn the
handle in the most convenient for operation po-
sition, and then tighten it well.
Do not carry the machine by a loose auxiliary
handle.
RECOMMENDATIONS FOR
OPERATION
Apply moderate pressure during operation (ap-
proximately 100-150 N)! Higher pressure will not
increase efficiency, but it will lead to decreasing
the operation life of the machine.
Watch out for the stage of chisel blunting and
replace it when considerable decrease of effi-
ciency is observed.
16
EN
Application

Maintenance

WARNING: Always ensure that the
tool is switched off and unplugged before
attempting to perform inspection or mainte-
nance.
Regulator position
A-B
C-D
E-G
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they
are properly tightened. Should any of the screws
be loose, retighten it immediately to avoid haz-
ards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
IMPORTANT! To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
Impact rate
1900-2085 min
-1
2265-2450 min
-1
2630-3000 min
-1
RS 613B