Emos H3019 Manual De Instrucciones página 5

GB | Colour Door Camera Unit
Package contents:
Camera unit
Mount
Attachment for adjusting the lens angle
RFID chips
Mounting material
Screwdriver
Manual
Description of the device: fig. 1a
1 – Microphone
2 – IR illumination
3 – Lens
4 – Numeric keypad
5 – IC reader – RFID chips
6 – Ring button
7 – Speaker
Description of the device: fig. 1b
1 – Video mode selection button
• Hold the button for 5 s to switch modes.
2 – Button for programming RFID key fobs
• Values are set using the turn knobs on the back of the
door camera unit (covered by a rubber seal).
3 – Button for setting the duration (1–10 s) for controlling the
door lock
• Values are set using the turn knobs on the back of the
door camera unit (covered by a rubber seal).
4 – Volume setting for the camera unit
Terminal Description
1 – red – 12 V
2 – white – audio
3 – black – GND
4 – yellow – video
Volt-Free Contacts
5 – green – NC
6 – blue – COM
7 – brown – NO
12 V Lock Outlet
8 – purple – +12 V for the lock
Button
9 – orange – EXIT button
External Power Supply
10 – grey – +12 V power supply
Entering the programming MENU:
Enter the factory preset code (123456) for entering the pro-
gramming MENU and press #. You will hear a double long beep.
Changing the code for entering the programming
MENU:
1. Press 0 and #. You will hear a single long beep.
2. Enter a new 6-digit code and press #. You will hear a single
long beep.
3. Press * to exit the programming MENU. You will hear a
double beep.
Setting an unlock code:
1. Input the code for entering the programming MENU (either
123456 or the code you chose). You will hear a double
long beep.
2. Press 1 and # to enter the password setting MENU. You will
hear a single long beep.
3. Enter a 3-digit location (cell) code from 000 to 199 and press
#. You will hear a long beep.
4. Enter a 6-digit code and press # to save the code in the
door unit's memory. You will hear a single long beep as
confirmation. If the given location (cell) is occupied, you will
hear a short double beep and have to repeat the process.
5. You can gradually add codes after hearing the confirmation
sound (a single long beep) by pressing #. The next code you
enter will be automatically saved into the next location (cell).
6. Press * twice to exit the programming MENU. You will hear
a short double beep.
Erasing an unlock code:
1. Input the code for entering the programming MENU (either
123456 or the code you chose). You will hear a double
long beep.
2. Press 2 and # to enter the code deletion mode. You will hear
a single long beep.
3. Enter the 3-digit location (cell) code (from 000 to 199) of the
cell you wish to delete the code for and press # to erase the
code for this location (cell). You will hear a single long beep.
5