Publicidad
Idiomas disponibles
Idiomas disponibles
3.- ASSEMBLY
No tools are necessary to assemble the hoist, although some parts are considerably heavy. It is therefore
advisable to use the assistance of a helper when handling such parts. Put particular attention to avoid being
knocked or trapped.
3.1.- Components (see page 3)
BASE STRUCTURE
1.- Mast base
2.- Pedals
3.- Back casters (with brake)
4.- Legs
5.- Front casters (without brake)
PLATFORM
6.- Platform feet
MAST – HANDLE STRUCTURE
7.- Mast
3.2.- Joining the pre-assembled structures (see page 4)
Remove packing carefully.
DON'T REMOVE THE GREY PLASTIC PIECES (A) OF THE MAST BASE
Place the base structure on the ground with the back casters braked. Insert the platform by inserting the two
bolts (B) into the holes in the mast base. Remove locking knob (D) and insert mast-handle structure (C) into base
estructure. Finally place the metal flange (E) that adjusts the assembly by the locking knob (D), making sure that
it is firm and tight. Check that the legs open and close normally and that the casters rotate correctly.
The electric actuator is not supplied and assembled on the hoist in the factory. If you need to assemble the
actuator, loosen the ring (J) securing the pin (K). To disassemble do the opposite operation.
Connect FIRMLY in the base charge the remote control (F) and the linear actuator (G).
4.- OPERATING INSTRUCTIONS
4.1.- Operating
To spread the legs, step on the left pedal. To narrow the legs, step on the right pedal. While transferring patients
and to negotiate doors and confined corridors, the legs should preferably be narrowed.
Lifting and lowering the patient is achieved by the electric actuator's action on the hoist boom. These
movements are easy to control using the two buttons (up and down) provided on the hand control. When the
boom reaches the upper or lower limit of its run, it stops automatically.
8.- Telescopic boom
9.- Handle for carer
10.- Handle for patient
11.- Support for sling
12.- Electric motor
13.- Battery charging base
14.- Removable battery
15.- Remote control
16.- Locking knob (initially on mast base)
17.- Mast bracket (actuator lower support)
18.- Boom bracket (actuator top support)
19.- Support for knees
ENGLISH
18
Publicidad
