Husqvarna CT 36A/A-V Manual De Usuario página 9

• Drain the fuel in an approved container outdoors and
away from sparks and flames.
Safety instructions for operation near edges
WARNING:
instructions that follow before you use the
product.
• There is a risk that the product falls when you
operate it near an edge. Always keep a minimum
of ⅔ of the product on a surface that is sufficiently
stable to hold the product weight.
• If the product falls, stop the engine before you lift the
product back to a surface that is sufficiently stable.
To lift the product with lifting equipment on
Refer to
page 23 .
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
• Stop the engine and make sure that all parts
of the product are cool before you perform the
maintenance.
To assemble the handlebar
1. On CT 36-5A EU FOLD-ADJ-T: Lift the handle until it
is straight and tighten the knob (A).
2. Attach the wires to the handlebar with cable ties.
1452 - 003 - 30.01.2023
Read the warning
Read the warning
Assembly
A
• Clean the product to remove fuel, oil or debris before
performing the maintenance.
• Disconnect the spark plug cap before you do the
maintenance.
• Worn blades can have sharp edges. Use protective
gloves and be careful around the blades.
• The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
• Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
• Always use original accessories and approved spare
parts. Accessories and spare parts that are not
approved by the manufacturer, can cause serious
injury or death.
• Replace damaged, worn or broken parts.
• Only do the maintenance as described in this
operator's manual. Let an approved service center
do all other servicing.
• Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
• After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
• Let an approved service center do servicing on the
product regularly.
To install the handle
1. Pull the blade pitch cable (A) from the bottom end of
the handle and remove the cable nut (B).
A
B
9