Publicidad
Idiomas disponibles
Idiomas disponibles
Coaxial digital output
This sets the output from the COAXIAL digital audio output
connector.
MENU
COAXIAL OUT
ON
OFF
No audio signal will be output from the COAXIAL digital audio
output connector.
ON
Audio signals will be output from the COAXIAL digital audio out-
put connector.
Optical digital output
This sets the output from the OPTICAL digital audio output
connector.
MENU
OPTICAL OUT
ON
OFF
No audio signal will be output from the OPTICAL digital audio
output connector.
ON
Audio signals will be output from the OPTICAL digital audio out-
put connector.
Information display
This shows the version of the firmware used by the unit.
MENU
VERSION INFO
SYSTEM
SYSTEM
The microcomputer firmware version
USB
The USB firmware version
FPGA
The FPGA firmware version
CD DRIVE
The CD drive firmware version
If you experience a problem with this product, please take a moment
to review the following information before requesting service. If it still
does not operate correctly, contact the retailer where you purchased
the unit.
General
The unit does not turn on.
e Check that the power cord is completely plugged into the
power outlet. If the outlet is switched, confirm that the switch
is in the ON position.
e Connect a different electrical device to the outlet to confirm
that it is supplying power.
e If the automatic power saving function has caused the unit to
enter standby, press the remote control STANDBY/ON button
to turn the unit on again.
The unit automatically enters standby mode.
e This is because the automatic power saving function put the
unit into standby. Set the STANDBY/ON switch to STANDBY
once and then set it to ON again.
Change the automatic power saving setting if necessary
(page 22).
Remote control does not work.
e Turn the main unit on (page 16).
e If the batteries are exhausted, replace both of them with new
ones (page 8).
e The remote control will not work if there are obstructions
between it and the main unit. Point the remote control at the
front panel of the unit from a distance of less than about 5 m
(16 ft) (page 8).
A television or other device is operating improperly.
e The use of this unit's remote control might cause some
televisions and other devices with wireless remote control
functions to operate incorrectly.
There is a humming noise.
e If a connecting cable is near a power cord, fluorescent light or
similar cause of interference, increase the distance between
them as much as possible.
No sound is output.
e If a stereo amplifier is connected to this unit, adjust its volume.
e Reconfirm the connections with other equipment.
Continued on the next page
e
Troubleshooting
EN
23
Publicidad
