Publicidad
TUTORIAL
SAV III:
Pre-assembled on Neptune III FFM
SAV III basic:
Code OR025030
DO NOT USE the SAV III Basic if any part is broken.
DO NOT DIVE YOUR OCEAN REEF IDM IF SAV IS LEAKING WATER OR AIR. TROUBLE
SHOOT THE SAV IF THERE IS SIGN OF WATER OR AIR LEAKAGE.
DO NOT OVERTIGHTEN OR OVER OPEN THE SAV – THIS CAN CAUSE THE VALVE CAP
OR SCREW/RING TO BECOME STUCK OR DIFFICULT TO OPERATE. As with all valves
operated while SCUBA diving, tightening, and opening should be done gently and
never with force. Saline, water, and other residues can affect operating the SAV.
Follow maintenance instructions properly to avoid issues.
It is essential that the diver using this product is properly trained and equipped and
fully understand these instructions before attempting to use the SAV. Testing the use
on surface and in confined water is strongly recommended.
While the SAV provides the diver the ability of breathing ambient air on surface, it
does not change or eliminate the potential hazards of diving. As a further component
of the diver's equipment, it should be operated according to this manual and included
in one's configuration only when fully understood and confident use achieved.
While our SAVs feature a valve to avoid water to rush in the mask when submerged,
this is intended in vertical position and normal diving trim position. According to the
position of the valve, leaking can be more serious. For this reason, the valve should
not be forgotten open, upon submerging as instructed in this manual.
Dust and any debris in the area of the SAV can cause malfunction in the product
or even compromise its correct use. In order to avoid this, before use, make
sure that the SAV is perfectly clean.
SAV III
*Sold separately for Neptune III basic and some configurations.
The Surface Air Valve / SAV III / SAV III basic allows the diver to breathe
ambient air while at the surface conserving the diver's gas supply.
To use, simply open the valve while on the surface or outside of the
water to breathe ambient air, and close it when ready to dive.
•
Easy to grab, sturdy design.
•
Large air vents
•
Easy to assemble on the mask
*The Surface Air Valve III Basic is retro compatible with all prior
OCEANREEF IDM models that do not have a Professional or Neptune III
SAV installed and an available OCTOPUS/SAV port. The Neptune III SAV
III is permanently installed on the IDM/FFM.
8.6 SAV III
Keep in mind cold water diving might require specific
procedures.
NEPTUNE III Package Owner's Manual rel. 2.1
17
Publicidad
