Publicidad
12 - ASSEMBLY OF THE DOFFING HANDLE
1
Unscrew the quick release system with a Phillips
screwdriver holding the bolt positioned on the
opposite side with one finger to prevent it from
accidentally falling.
2
Slightly open the two parts of the cover at the
bottom, making sure that the joint at the top
remains in place. Insert the loop and close the two
parts of the cover so that the screw can catch the
bolt's threading.
3
Tighten the screw remembering to always hold the
bolt on the opposite side with one finger.
There must be no space between the two parts of
the cover.
26
"Pull to remove the mask" text should be facing
inwards – towards your neck when wearing the mask,
while the group logo should face out, towards the
front of the mask.
Pull the handle to ensure it is assembled
correctly - holding on to the screws.
Repeat this procedure on the other side. Once
finished, check that the length of the laces is
identical on both sides and that the handle is
positioned securely (don and doff the mask a few
NEPTUNE III Package Owner's Manual rel. 2.1
(OPTIONAL)
times).
Publicidad
