Publicidad
Idiomas disponibles
Idiomas disponibles
B
Product usage
Product usage
WARNING!
•
Make sure that the room is well ventilated when using the unit.
•
Place the unit upright on a flat, dry surface in a safe area to prevent it from
tipping over.
•
Arrange the cable in such a way that it is not near any doorways or thoroughfares,
where people could step on or trip over it.
•
Do not place the unit near a window where it could be exposed to rain.
1.
Fully unwind the power cable and securely plug it into a suitable mains socket. Once
powered, the unit will beep twice and enter Standby mode.
2.
Press the
button to turn on the unit.
3.
Press the
/
button to toggle between the 3 fan modes (Normal/ Night-time/Natural
ventilation).
4.
Press the
/
button to increase or decrease the fan speed (Normal ventilation) or to
select a predefined ventilation programme (Night-time ventilation/Natural ventilation).
5.
Press the
button to start or stop the automatic left-right air flow oscillation.
6.
See the "Control panel and remote control description" section above for more information.
NOTE: After approx. 1 minute of inactivity (no buttons being pressed), the display
will turn off to save power whilst the fan continues to operate (speed, fan mode,
oscillation and timer). Press any button (except
again.
7.
When you have finished using the unit, press the
(off) mode and unplug the power cable from the mains socket.
Important: Always unplug the unit from the mains socket whenever it is no longer
in use to fully disconnect it from the power source.
Replacing the remote control battery
If the remote control battery is dead, only replace it with the same or an equivalent type.
•
Hold the remote control with the back facing upwards.
•
Place your thumb (or a flat screwdriver) on the bottom of the remote to push and hold
the small locking clip towards the opposite side, as shown. Then pull the groove of the
battery compartment to slide it out.
•
Install a new battery (1x 3 V CR2032 button battery) with its + side facing upwards, and
close the compartment.
) to turn the display back on
button to make the unit enter Standby
26
EN
Publicidad
