Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Remove the spark arrestor cover.
5.
Remove the spark arrestor screen from the spark arrestor cover
(Fig. 28).
6.
Clean the spark arrestor screen with a wire brush or replace it.
7.
Reinstall the spark arrestor screen, spark arrestor cover and screws.
CLEANING
WARNING:
To avoid serious personal injury, always
turn your unit off and allow it to cool before you clean
or service it.
Use a small brush to clean off the outside of the unit. Do not use strong
detergents. Household cleaners that contain aromatic oils such as pine
and lemon, and solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
STORAGE
• Never store the unit with fuel in the tank where fumes may reach
an open flame or spark.
• Allow the engine to cool before storing.
• Lock up the unit to prevent unauthorized use or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
MAINTENANCE AND REPAIR INSTRUCTIONS
LONG TERM STORAGE
If you plan on storing the unit for an extended time, use the
following storage procedure:
1.
Drain all fuel from the fuel tank into a container with the same
2-cycle fuel mixture. Do not use fuel that has been stored for
more than 60 days. Dispose of the old fuel/oil mix in
accordance to Federal, State and Local regulations.
2.
Start the engine and allow it to run until it stalls. This ensures
that all fuel has been drained from the carburetor.
3.
Allow the engine to cool. Remove the spark plug and put 1 oz.
(30 ml) of any high quality motor oil or 2-cycle oil into the
cylinder. Pull the starter rope slowly to distribute the oil.
Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the oil from the
cylinder before attempting to start the trimmer after
storage.
4.
Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and tighten
loose screws, nuts or bolts. The unit is ready for storage.
TRANSPORTING
• Allow the engine to cool before transporting
• Drain fuel from unit
• Tighten fuel cap before transporting
• Secure the unit while transporting
13
Publicidad
